Nichrome 80 Ribbon Wire 100FT+ Spool
Wire Buddha Nichrome 80 Ribbon wire is European smelted wire that has been milled in the USA to bring you the best ribbon for all your standard and exotic coil builds.
Nichrome 80 is a austenitic nickel-chromium Alloy and has a very high resistivity and oxidization resistance. Wire Buddha wire is composed of 80% Nickel and 20% Chromium and is Iron free. For use in Rebuildable atomizers this wire has a lower operating temperature (1200°C) than Kanthal A1 and can last longer than it because of its ability to resist oxidation. Kanthal A1 has a thinner oxide layer when comparing it to Kanthal A1 and but is prone to getting hot spots compared to Kanthal A1. Wire Buddha Nichrome 80 comes on a nice large easy to use spool, perfect for any builder who is serious about making better coils. All Wire Buddha Nichrome 80 comes on a large 10cm diameter spool which makes these very easy to use.
This wire may or may not be intended for standard single wire coil builds, this wire may be intended for advanced coil builds and will not perform well as a standalone wire. Please make sure you are buying the most suitable wire for your build before purchasing.
Rebuilding is for experienced users only and a knowledge of ohms law should be taken into account when building coils for Rebuildable Atomizer’s. Always exercise caution building your atomizer, always check your build’s resistance on an ohm reader before firing it on any device. Coils that are touching any part of the deck, air flow controller or any part of the coil touching any of the atomizer’s posts can result in a short and can cause serious damage to your devices if not checked on an ohm reader before use. Make sure to use high drain and high amperage batteries when using advanced user devices.